Pharmaqo Labs Androbolan 400 (Test/Mast/Primo)

Androbolan 400 can cause bad PIP due to high concentration. Using a smaller needle might help reduce it.

Hey I’ve just started this and I will say pip is on point with this one

Yeah pip was bad with this, I got around it by adding more primo to the solution, effectively changing the concentration levels, it was much better then

Yeah, PIP was bad — fixed it by adding more Primo to dilute the concentration. Much better after that.

I’ve also been reading up on the PharmaQo Labs Androbolan 400 — the blend looks solid on paper, but yeah, the reports of bad PIP are hard to ignore. High-concentration mixes like this (Test/Mast/Primo at 400mg/ml) can definitely be tougher on the muscle, especially if the carrier oil is thick or the injection volume is on the higher side.

It’s possible that some users are pinning with a gauge that’s too large or injecting too fast, which can make it worse. I've seen a few people suggest warming the vial and splitting the dose across injection sites to ease the discomfort.

Would love to hear from anyone who’s run that specific PharmaQo Labs blend and had a smoother experience — maybe it's batch-specific or just a technique issue?

I've run this, the pip is horrible. I've even diluted it but adding more primo crumb a standalone vial but it's still bad. I use a smaller needle, injected slowly and warned up the solution and none of it helped. I even injected subq but the lumps were massive.

I’ve actually run PharmaQo Labs Androbolan 400 and had a good experience with it. Yeah, it’s a high-concentration blend so you might feel a little more bite than plain Test-E, but nothing crazy if you pin it right.

I used a 25G needle, warmed the vial slightly before drawing, and injected slowly — barely any PIP at all. Some people go too fast or use a thick gauge and then blame the gear.

Honestly, quality was solid and results were on point. If you’ve been fine with Test-E, you’ll probably handle this just fine with the right pinning protocol.

Where did hit pin it to? I pinned into my delts. Did it slow over a minute to inject 1ml. But I also went subq and had really big lumps. Also warned it up

Don’t go subq with 1 mL oil → causes lumps. Stick to intramuscular (delts, glutes, quads).

Warm the oil + inject very slowly → you’re already doing this right.

Massage & move the muscle after → helps disperse the oil.

Rotate sites → don’t hit the same spot too often.

Small lumps are normal → they’ll go down in a few days unless red, hot, or very painful (infection).

Did all the but the pip pain was bad with the androgen 400. I've changed back to individual compounds and it's far better

Yeah, Androgen 400 can cause bad PIP. Switching to separate compounds is definitely smoother.